S-200C
TECHNICAL PRODUCT BULLETIN #B-56
USEPA, OEM REGULATIONS IMPLEMENTATION DIVISION
LISTING DATE: JULY 24, 2002
"S-200C"
I. NAME, BRAND, OR TRADEMARK |
---|
S-200C Type of Product: Bioremediation Agent (Nutrient Additive) |
II. NAME, ADDRESS, AND TELEPHONE NUMBER OF MANUFACTURER/CONTACT |
---|
RBL Environmental, LLC* 1311 Dorothy Avenue Phoenixville, PA 19460 Phone: (610) 520-7665 E-mail: jim.lynn@iepusa.com (Mr. James Lynn) (*RBL Environmental, LLC is the manufacturer and marketer for International Environmental Products) |
III. NAME, ADDRESS, AND TELEPHONE NUMBER OF PRIMARY DISTRIBUTORS |
---|
RBL Environmental, LLC 1311 Dorothy Avenue Phoenixville, PA 19460 Phone: (610) 520-7665 E-mail: jim.lynn@iepusa.com (Mr. James Lynn) |
IV. SPECIAL HANDLING AND WORKER PRECAUTIONS FOR STORAGE AND FIELD APPLICATION |
---|
1. Flammability: Non-flammable. 2. Ventilation: Ventilation of the work place is not necessary. 3. Skin and eye contact; protective clothing; treatment in case of contact: In case of contact with skin or eyes, wash with plenty of water. 4.a. Maximum storage temperature: 132ºF 4.b. Minimum storage temperature: 32ºF 4.c. Optimum storage temperature range: 55ºF - 85ºF 4.d. Temperatures of phase separations: <32ºF and >140ºF |
V. SHELF LIFE |
---|
The recommended shelf life of S-200C is 1½ years if kept in the unopened original container. |
VI. RECOMMENDED APPLICATION PROCEDURE |
---|
1. Application Method: S-200C is a light amber liquid, and as such can be sprayed with traditional liquid spraying equipment, such as pressurized sprayers or backpack sprayers. 2. Concentration/Application Rate: The recommended application rate is approximately 10% by volume of the S-200C as compared to the hydrocarbon being remediated. In other words, use 1 pound of S-200C for every 10 pounds of hydrocarbon you are remediating. For applications on soil contaminated below 1 foot, the soil is turned and the material is applied. This allows air to circulate and thereby maintains an aerobic condition. On a surface application, the amount to use is approximately 0.1 to 1 pound of S-200C for every square yard of surface area. The amount sprayed is dependent on the amount of hydrocarbon on the surface you are spraying. To remediate a sheen on water, the same application ratio for a surface application is used. 3. Conditions for Use: S-200C is a bioremediation accelerator used for the remediation of hydrocarbon spills or leaks. It is a non-intrusive, cost effective remedy for the cleanup of these hydrocarbons. These hydrocarbons include but are not limited to gasoline, No. 2 to No. 6 diesel fuel, jet fuels, kerosene, lubricating oils, hydraulic oils, and crude oils. |
VII. TOXICITY AND EFFECTIVENESS | |||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
a. Toxicity
b. Effectiveness: Bioremediation Agent Effectiveness Test (40 CFR 300.900), Federal Register September 15, 1994: Summary Data Table:
Results of Gravimetric Analysis: Percentage (%) Decrease in Weight of Oil on Day 28
|
VIII. MICROBIOLOGICAL ANALYSIS |
---|
1. Listing of all microorganisms by species and percentages in the composition: S-200C is a nutrient bioremediation accelerator and does not contain bacterial cultures or amendments. However, with the addition of S-200C, the microbiological data shows a continued viability of microbial incubations over time. 2. Optimum pH, temperature, and salinity ranges for use of the additive: pH: 7.0 Temperature: 86ºF Salinity: Fresh to salt water 3. Minimum and maximum pH, temperature, and salinity levels below or above which the effectiveness of the additive is reduced to half its optimum capacity: pH: 4.5 - 10.0 Temperature: 50ºF - 120ºF Salinity: 0% - 10% 4. Special nutrient requirements: NA 5. Test results regarding the determination of the presence of the following: Salmonella: Negative Fecal coliform: Negative Shigella: Negative Staphylococcus Coagulase positive: Negative Beta hemolytic Streptococci: Negative |
IX. PHYSICAL PROPERTIES |
---|
1. Flash Point: > 212ºF 2. Pour Point: 40ºF 3. Viscosity: 100cp @ 70ºF 4. Specific Gravity: 0.996 5. pH: 4.5 6. Surface Active Agents: NA 7. Solvents: NA 8. Additives: NA 9. Solubility in Water: Dispersable |
X. ANALYSIS FOR HEAVY METALS, CYANIDE, AND CHLORINATED HYDROCARBONS |
---|
S-200C does not contain any heavy metals, cyanide, or chlorinated hydrocarbons. |